= SALEEN SPEEDLAB SUSPENSION KIT INSTALLATION MANUAL: 2005 Mustang P/N: 10-8002-C11790A Saleen Performance, Inc. 76 Fairbanks Irvine, C
10 III Front Sway Bar Removal Figure 1 Figure 2 Order of Operations: NOTE: Keep all hardware for installation of new
11 IV Front Strut Subassembly Part Number Description Qty. 06-1302-C09816a Strut Front Coupe 2 06-1302-C09731a Spring Front Coupe 2
12 Figure 4 Figure 5 4. Obtain the bump stop from the stock strut, and cut it with a hack saw at the line shown
13 V Front and Rear Shock Decal Installation Part Number Description Qty. 06-1302-C09816 Strut Front Coupe 2 06-1302-B09916* Shock Rear Coupe 2
14 VI Front Struts Installation Part Number Description Qty. 06-1302-B09913* Strut Front Assembly Coupe 2 Figure 1 F
15 VII Front Sway Bar Subassembly Part Number Description Qty. 06-1303-C09503 Swaybar Front 1 00-1303-C09515* Bushing Swaybar Front 2 00-1303-C0
16 VIII Front Sway Bar Installation Part Number Description Qty. 06-1303-B09915* Swaybar Front Assembly 1 Figure 1
17 IX Rear Suspension Removal Figure 1 Order of Operations: NOTE: Keep ALL hardware and rubber spring boots for inst
18 Figure 3 6. Let the axle hang. Note the orientation of the rear springs, how there is a shortened vertical dis
19 X Rear Suspension Installation Part Number Description Qty. 06-1302-C09818 Shock Rear Coupe 2 06-1302-C09819 Spring Rear Coupe 2
2 IF YOU ARE NOT EXPERIENCED IN THE AREA OF AUTOMOTIVE MECHANICS, WE STRONGLY URGE THAT YOU REFER THIS INSTALLATION TO A CERTIFIED IN
20 4. The bump stop has to be modified. Figure 3 shows the unmodified bump stop with the proper cut line, and Figure 4 shows the modified bump
3 Saleen Speedlab Suspension Kit Installation Guide for 2005 Mustang WELCOME! Thank you for buying the Saleen Speedlab Suspension Kit for the
4 Table of Contents Saleen Chassis Fasteners and Torques…………………………………..6 I Wheel Removal…………………………………….…………….………7 II Front Struts Removal…………
5 OBTAIN THE FOLLOWING TOOLS: • Spring compressor • 10 mm wrench • ¼” wrench • ½” drive Ft-lb torqu
6 The following table lists the proper torque values to follow when fastening all suspension components; note also the recommendations for the
7 I Wheel Removal Figure 1 Order of Operations: 1. Jack up the front of the car, and place jack stands underneath
8 II Front Struts Removal Figure 1 Order of Operations: NOTE: Keep ALL hardware for installation of new suspension c
9 Figure 5 3. Unbolt the brake line from the strut using the 3/8” impact with the 10mm socket. Remove the Christ
Kommentare zu diesen Handbüchern